IKEA LACK LIFT CUBE от AllThingss3D

Модель
loading...
Описание Модели
This is a printed cube to lift your IKEA LACK table 40cm higher. For example if you want to put something under the table but the table is to low. Print in either...Показать больше
PLA or ABS with min 50% infill depending on the weight that will be put on the table. 4 holes for screws are in place at the bottom. The screw hole is 8mm wide. You will need to print 4 cube`s for 1 IKEA LACK table.
Об авторе этой модели
1 model upload
Подтвержденный профиль