240x180x2 mm Picture Frame Glass holder for Replicator by Lesley_3ddes

loading...
Model Description
3D model of aubenc. The models were repaired and checked for printability.

Mind the zero height of the Z stage!!

Because the glass is 2mm thick you'll need...Show more to either install the build platform 2mm lower or trigger the Z end-stop 2 mm earlier!

Use ABS! and give it an acetone/acetone-vapor bath.

The parts will warp due to the heat of the build platform but this should no be severe enough to have any bad consequence.

Do not use PLA! unless you'll never use the heated build platform.

This time the clips are not in the way of the nozzle(s).
About The Model’s Author
50 models uploaded
Approved profile