3D model of uwcharlie1983. The models were repaired and checked for printability.
This a weighted poker card capper. It is placed on your hole cards during a hand
...Show more to make sure they are not accidentally folded. The bottom of the basket is designed with the same diameter (39mm) as a standard size poker chip so this will stack perfectly on your chips when not in use.
This design is a snake being charmed in a woven basket.
--- Printing ---
1) Print one each of the parts.
2) I printed the holder (upside down) and basket with line support material spaced at 4.5mm.
--- Assembly ---
1) The holder is designed to have 4 nickels placed inside of it as ballast prior to it being snapped into the basket.
2) With the nickels inside the holder snap the basket over the top of it.
3) Slide the cobra onto the tab inside the basket. The parts are designed to stay together without glue, but you can add a few drops if you want to guarantee they never come apart.
Printer brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
Yes
Resolution:
0.1 mm
Infill:
15%
