3D model of tomstanton
The models were repaired and checked for printability.
These stl files are upgrades for an air powered toy car to make it radio controlled.
...显示更多 You don't need to use the bottle mount, especially if you wish to still use the built in pump, but it allows for a large bottle to be used and therefore longer run time.
Air powered car
Other parts required:
1pc RC car controller + receiver
1pc 5v regulator (to power the receiver and servo)
1pc 2s 7.4v lipo battery (I used a 2s 300mah lipo)
1pc 9g servo
3pcs M3x16 mm bolt
2pcs short lengths of wire for the steering rods
1pcs tubeless presta valve (if you wish to run your own larger bottle)
https://www.instagram.com/tom__stanton
