3D model of iczfirz
The models were repaired and checked for printability.
Yet another easy printable and usable air purifier.
Super scalable. Easy print even
...Show more scale down to Car Cup Holder size and unlimited scale up.
I made this for my loves in office area in the day of the Covid-19.
Good Luck everyone and my loves.
Printer:
150 x 150 up
Rafts:
No
Supports:
No
Resolution:
0.25mm
Infill:
20%
Filament brand:
Any
Filament color:
Any
Filament material:
Any PLA
I assume all STL are good to various fans size. Simply resize in slicer by the following scale factor.
example1 > Option 1 + 92mm fan = all STL scale factor 1/80*92
example2 > Option 2 + 92mm fan = all STL scale factor 1/120*92
example3 > Option 2 + 80mm fan = all STL scale factor 1/120*80
Too small scale factor may hit the thin wall problem.
About STL:
-Reverse cover and body to print.
-No reverse for body_simply, fan mount, etc.
-AP130_Body_Simply.stl // No legs, no cone version. Save ~30% PLA. (97g vs 134g)
-AP130_InnerHex.stl // To hold the fliter from inside, if you have 400x400 bed size, print the flat version.
-AP130_InnerHex_flat.stl // Fast print time but only if you have 430x430 bed size. 1mm Z thickness + hairdryer, you can easily reshape it by rolling it outside the body
-AP130_InnerHex_flat_half.stl // Same as above but splited to half. You need 2 prints.
There is no lock and latch for the cover to the body. And it's quite loosey. This is by design because I'm do think people will just hold the cover to lift up the whole unit. No good.
No wiring trunks and holes in STL. Go ahead DIY.
Notes:
-Use any filter you trust. Personally I use 3M Filtrete™ (Air Cleaning Filter - Ultra Allergen Reduction)
-Fan should be under the mount for the best air flow(Animations contain error :p).
-CA glue the fan mount to the cover.
If duct motor mount is too big to fit inside the cover, heat it up to 140°C for around than 15 minutes. Because PLA shrinks when annealed (about 2%)
-Add LED. Eyes candy.
-Work well with tea bag and active carbon. Just drop in.
https://www.instagram.com/iczfirz/
