52mm Goblin Knight Charging on Giant Wolf от Lindsey_3d

Модель
loading...
Описание Модели
3D model of gamescape3d
The models were repaired and checked for printability.

Pesky adventurers raiding your dungeon, cleaning out your stash? You need this...Показать больше
Goblin Knight to to run them through, play in their guts, and pike their heads at the dungeon door. This model is designed for HIPS printing. It is one of five yet to be finished wolf riders. Check blog and/or instructions below for specific settings. If you don't print Hips I'd scale up about 50%.

ASSEMBLY REQUIRED:Will likely require xacto blade, or sanding, and superglue to assemble weapons/shields to figure. We advise the following settings for slicing
Layer height: Between .15mm
auto_support: Between 1- 1.5mm
Fill Density: 40% or greater

Duel Extrude
HIPS
Smart ABS

25% fill on wolf
40-70% fill on goblin

Feed Rates
“feedrate”: 50,
“temperature_disabled”: 230.0
},
“firstlayerraft”: {
“feedrate”: 50,
“temperature_disabled”: 230.0
},
“infill”: {
“feedrate”: 50,
“temperature_disabled”: 230.0
},
“insets”: {
“feedrate”: 50,
“temperature_disabled”: 230.0
},
“outlines”: {
“feedrate”: 20,
“temperature_disabled”: 230.0
},
“raftbase”: {
“feedrate”: 10,
“temperature_disabled”: 230.0
http://twitter.com/GameScape3D
Об авторе этой модели
36 models uploaded
Подтвержденный профиль