Minotaur 54mm von Lindsey_3d

Modell von
loading...
Modellbeschreibung
3D model of gamescape3d
The models were repaired and checked for printability.

Back after short RL Hiatus, I finished this late last month
52 mm Minotaur stands...Zeig mehr about 70mm. Lightly Inspired by KOBL Minotaur. I highly suggest HIPS printing for my figures on FFF machines however this fella should be large enough to manage without. I also suggest dialing down the speed for HIPS printing, see below

This model is designed for HIPS printing.

ASSEMBLY REQUIRED:Will likely require xacto blade, or sanding, and superglue to assemble weapons/shields to figure. We advise the following settings for slicing
Layer height: Between .2mm
auto_support: Between 1- 1.5mm or 40-50% HIPS fill
Fill Density: 15% or greater
3 shells
Print speed
30 outlines
75 fill
Other notes
glass plate with HIPS slurry allows for plate to heat only to 100c without issue.

Printer brand:
MakerBot

Printer:
MakerBot Replicator

Rafts:
Yes

Supports:
Yes

Resolution:
350000 poly

Infill:
15%

Notes:
Dissolvable filament print.

Acetone brushed flesh areas, acrylic paint
http://twitter.com/GameScape3D
Über den Autor des Modells
36 models uploaded
Genehmigtes Profil