3D model of thenewhobbyist
The models were repaired and checked for printability.
This is a replacement clip for a tackle box I purchased. The model can likely be
...Zeig mehr scaled to fit your needs, though I'm not sure if there are any "standard" clip sizes. I modeled the part from the original manufactures piece using a photograph, a digital caliper and Google Sketchup. This may be a good candidate for OpenSCAD but I've yet to learn how to use it.
The replacement I printed actually snaps and holds tighter than the clip from the manufacturer!
1. Scale to fit your box
2. Print
3. Be content with the fact that you repaired something rather than replaced it.
http://twitter.com/TheNewHobbyist
