3D model of designmaketeach
The models were repaired and checked for printability.
Welcome the New Year with a 2015 Strawtopper Gimbal. A 3D printed party favor
...Show more that is fun for kids and adults. Blow gently to spin the gimbal.
Printed at 0.2mm layer height on a Metal Printrbot Simple.
This design should print nicely on a Printrbot Metal Simple with no raft or support. Should spin right off the print bed with minimal work. If the rings are fused, try adjusting the filament diameter. I usually start by adding 0.1mm to the measured diameter of the filament I am using. If the filament measure 1.68mm using digital calipers, I will tell me slicing software that the filament diameter is 1.78mm.
https://www.instagram.com/designmaketeach/
