May 28, 2019
sent a couple extra prints too!
Printed on: FlashForge Creator Pro
Material: ABS
White
Review image #737803
May 20, 2019
Both prints looked really good in the proofs, but when I received them one had a small 1 cm long and .2mm delamination of the print at the top of the fingers on one side not shown in the proof photos. Both played well and where nicely cleaned of supports
Printed on: Creality CR-10 (ABS, PC)
Material: ABS
White
May 20, 2019
Very good. will order again here....
Printed on: Original Prusa i3 MK3
Material: ABS
White