TrollHunter Amulet of Daylight (Spinning Vers

Model by
Gravatar image
loading...
Size: 0.39 x 0.39 x 0.12 in x 1
Size: 4.16 x 4.81 x 0.94 in x 1
Model Description
After printing out a Amulet of Daylight I decided the inside really needed to spin.
So with an old copy of nettfab basic and TinkerCad I modified the original...Show more files. Adding a post, holes and cap to keep it in place.

I made a version with the troll_topper attached in case you wanted to print it as one part. (this does require supports) It is a tight fit but the center disk will slip in under the troll_toper and onto the post.

I noticed that with the original version the inside disk would hit the troll_toper teeth if I spun it to fast. So I made a second version with a extra mm of clearance.
About The Model’s Author
Gravatar image
No uploads
Approved profile