MakerBot - the Lunchbox! by A.I.M.E.E.

Model by
Model Description
3D model of mr_megatronic. The models were repaired and checked for printability.

This is probably only large enough to take a sandwich and a Capri-Sun, or a...Show more Lunchable... but hey! You can store other things in it too! I'll upload a lid without the "Lunchbox" line a bit later after my print of this completes and then the source files.


UPDATE: After printing the lid, it's obvious the hinge and the lid are a bit flimsy for the task at hand so if you print the files that are up right now, do so at 100% infill for the best strength.

I'll update this with a re-thought snap and hinge shortly.


Print the lid, body and both pins. UPDATE: I recommend printing the whole thing at 100% infill!
About The Model’s Author
23 models uploaded
Approved profile