Ender 3 all in one, universal rear electronics case от Dennis_3dwor

Модель
loading...
Описание Модели
3D model of teachingtech
The models were repaired and checked for printability.

A rear mounted electronics case for the Ender 3. At the back, there is room to...Показать больше
mount a Raspberry Pi, fan, buck converter and two relays on the left. On the right, either the standard board with four TL smoothers or an MKS Gen L or SKR1.3.

This design is modular, neat, quiet and offers better cable management than the factory design. Rear access is achieved with one bolt per side, without the need to turn the printer on its side. There's also enough room for other stepper motor drivers with large heat sinks if using an upgrade board.

STEP files added. Already some great remixes. Also, I've run some 14 hour prints with the Noctua 40x10mm fan with no stepper driver overheating or layer shifts.

29/6/20 - Right hand case piece added to suit SKR mini E3, TH3D EZboard Lite or standard board when TL smoothers are not in use. The mounts for those are removed and the mainboard mount shifted right to make access a little easier.

Printer brand:
Creality

Printer:
Ender 3

Rafts:
No

Supports:
No

Resolution:
0.2mm

Infill:
20%

Filament brand:
X3D

Filament color:
black

Filament material:
PLA

Notes:
All parts are correctly oriented, no support needed.

Assemble as shown in the video. The pin27 board hump version is currently untested, feedback welcome.
www.youtube.com/c/teachingtech
Об авторе этой модели
27 models uploaded
Подтвержденный профиль