Rough Wood-effect Chest von Tim_3dworld

Modell von
loading...
Modellbeschreibung
3D model of francfalco
The models were repaired and checked for printability.

There's always room for another 3D printed box!
This was an experiment in...Zeig mehr achieving a 'real' wood effect using ColorFabb Woodfill filament.

ColorFabb filament is great stuff, but it didn't give me the 'real' wood surface finish i was looking for.

So i designed and modelled this simple little chest, spending a lot of time creating the wood grain texture onto all surfaces and faux Dovetail joints. And to complete, i just had to add some hinges and a latch.

Printed in ColourFabb Woodfill and Faberdashery Robot Siver PLA

The file sizes are quite large - sorry about that, but the wood texture surface effect needed a high model poly-count to achieve the detail. I may see if can optimise those.

Enjoy!

Printer brand:
Ultimaker

Printer:
Ultimaker 2

Rafts:
Yes

Supports:
No

Resolution:
Low for the chest High for the hinges and latch

Infill:
35%

Notes:
I printed all parts of the Chest with a 0.8mm nozzle @ 0.4mm layer height

I printed the hinges and latch with a 0.25 nozzle @ 0.1mm layer height

The ChestLid file prints on its end, so i added a '10 walled Brim' to give it support whilst printing.

All other parts printed without support or raft.

Use a good plastic/wood glue to fix all parts together

The file sizes are quite large - sorry about that, but the wood texture surface effect needed a high model poly-count to achieve the detail. I may see if can optimise those.

All files sliced and printed without issue.
http://twitter.com/francfalco
Über den Autor des Modells
47 models uploaded
Genehmigtes Profil