Purple Worm von 3dmodels_by_

loading...
Modellbeschreibung
3D model of daandruff
The models were repaired and checked for printability.

Here's a Purple Worm from DnD. I wanted to make my own design of it and make it...Zeig mehr as printer-friendly as I could. If you print a couple of extra bases, you can use them as burrow holes as well.

Printer:
Anet A8

Rafts:
No

Supports:
Yes

Resolution:
0.2mm

Infill:
10%

Notes:
Print it as two halves, your slicer should be able to care of that (otherwise, you could use MeshMixer). There's a small artifact inside of the body, but it doesn't effect the final print and doesn't make the print any harder so just ignore it ;)
Über den Autor des Modells
9 models uploaded
Genehmigtes Profil