Octopus Magnet by Joy_designs

Model by
Model Description
3D model of 3dcentralva
The models were repaired and checked for printability.

This is an extension from the popular octopus thick legs. We made room for a magnet...Show more to fit, such that it will be snug to your fridge.

It was made to fit with 1/2-Inch by 1/16-Inch Rare Earth Disc Magnets

1. Print the STL with minimal support.
2. On the magnet hole on the underside of the octopus, either apply superglue or a few drops of acetone.
3. Insert magnet -- but be careful! it's a snug fit, so especially in the case of acetone, beware the acetone might splash out (you do not want this in your eyes)
About The Model’s Author
16 models uploaded
Approved profile