3D model of deweycat
The models were repaired and checked for printability.
This is a derivative of the accredited file as well as my earlier two story adaptation
...Show more of that file. i took my earlier two story building and removed the second floor and adapted the roof section to remove the partial window and added stucco and exposed brick section.
The building can be printed at 0.3mm layer settings, with supports, due to the overhanging bits on the exterior.
I primed with a grey rattle can spray primer and used craft paint to do the finishing, followed by an ink wash and dry brush before a spray matte finish.
For variation, use the "mirror" setting of your slicer to create a mirror images building. just be sure to do it to both files; it won't make a difference in this case but does in others and it is good to get into the habit of mirroring ALL files in the same collection. I speak from experience.
Supports:
Yes
Resolution:
0.03
https://www.facebook.com/deweycatproductions
